結構特點
·采用鑲柱式定轉子設計，具有更高的配油精度及機械效率。
·雙滾動軸承設計,具有更大的側向承載能力。
·可靠的軸密封設計，承受背壓高，可以串并聯使用。
·正反轉換向方便、轉速平穩。
·多種油口、輸出軸、法蘭等連接形式。

Characteristic features：
It adapts the gerolor design, which has a higher distribution accuracy and mechanical efficiency.
The motor can be used in high pressure and high torque.
Double taper roller bearings permit high radial loads.
Credible design for shaft seal , which can bear high pressure.
A variety of connection types of flange, output shaft and oil port.

1.最大工作壓力指入口最大壓力，額定壓力指工作壓差。
2.馬達不能同時在最大壓力和最高轉速下工作。
3.在斷續工作條件下，運行時間每分鐘不得超過10%。
4.推薦用68#抗磨液壓油，粘度37-73cSt,清潔度ISO18/13。
5.最高工作油溫80°。
6.馬達全負荷工作前，應在最高工作壓力的40%以下磨合1小時。
7.馬達允許最高背壓10MPa，但建議不要超過5MPa，超過時應接外泄油管.
Note: 
1. Intermittent means the entrance of maximum pressure; continuous working pressure means the differential pressure.
2. Motor should not work under the highest pressure and the maximum speed.
3. The running time should not exceed 10% under intermittent working conditions.
4. The Maximum working temperature is 80℃.
5. The maximum allowable back pressure is 10Mpa, but the recommended back pressure should not exceed 5MP, a leaking pipes is needed when exceeding.
6. One hour running time under 40% of maximum working pressure is recommended before full capacity working.
7. Recommending N68 anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO 18/13.